Product 04
Classic Epoxy. Industrial Strength.
Two-component epoxy adhesive with transparent bond, heat resistance, and waterproof performance across metal, ceramic, stone, wood, and concrete.
10 Parts
8 Parts
Heat & waterproof — cures to a clear, strong adhesive joint
Industrial-grade two-component epoxy — bonds virtually any construction substrate.
Cures to a clear, virtually invisible adhesive joint — ideal for bonding visible surfaces where aesthetics matter.
Fully cured epoxy bond resists water and moisture, making it suitable for wet-area applications and outdoor use.
Bond integrity is maintained at elevated temperatures — suitable for applications near heat sources or in warm environments.
Bonds metal, ceramic, glass, marble, granite, concrete, wood, and most rigid construction materials in a single product.
Two-component chemistry creates an adhesive bond strong enough for structural repair and load-bearing applications.
Non-sagging formulation fills surface gaps and irregularities, ensuring a consistent bond across uneven joints.
Structural metal repairs, fixtures, brackets, and joint bonding in construction and industrial maintenance.
Bonding chipped ceramics, broken tile corners, and ornamental ceramic pieces in wet and dry areas.
Bonding stone cladding, marble countertop repairs, and natural stone restoration projects.
Joinery repairs, furniture bonding, and wooden fixture installation where water resistance is required.
Bonding pre-cast concrete elements, patching structural cracks, and anchoring fasteners in concrete.
Bonding glass panels, mirrors, and glass-to-frame applications where a transparent joint is critical.
Two-component epoxy — correct mixing and surface prep are essential.
Both bonding surfaces must be clean, dry, and free from dust, oil, grease, paint, or rust. Roughen smooth surfaces lightly with sandpaper for better adhesion.
Mix Epoxy Resin (Part A) and Hardener (Part B) at a 10:8 ratio by weight or volume. Mix thoroughly on a clean surface until the two components are fully blended with a uniform color.
Apply the mixed adhesive to one or both surfaces. Press the surfaces firmly together, ensuring full contact. Remove any excess adhesive squeeze-out immediately.
Keep the bonded assembly under firm pressure until initial set is achieved. Allow full cure time before subjecting the joint to load or stress. Do not disturb during curing.
Ready to Order?
Contact us for bulk pricing, technical guidance, or to find your nearest dealer.
